Wagan Tech Mini Stepper Master Manual De Usuario página 3

ASSEMBLY
1. Run the Power Cable (1), located in the tube of the Main Frame (3)
through the Stand Tube (2). Be careful not to pull/push the sensor that is
connected to the Power Cable too far in.
2. Connect the Stand Tube (2) to the Main Frame (3) with supplied short bolts
and washers (4).
3. Run the Power Cable (1) through the Connecting Tube (5).
4. Connect the Connecting Tube (5) to the Stand Tube (2) with supplied short
bolts and washers (4).
5. Connect the Power Cable (1) to the underside of the LCD Meter (6)
6. Cap the LCD Meter (6) onto the top of the Connecting Tube (5).
7. Connect the two Handle Bars (7) to either side of the Connecting Tube (5)
with supplied long bolts and washers (8).
*If the cable is not in the main frame, check both the Stand Tube (2) and the Connecting
Tube (5).
MAINTENANCE
• Inspect the Mini Stepper Master thoroughly at regular intervals to check to
see whether there are loose joints, loose hydraulic parts, wobbling pedals
and/or parts that have been damaged or worn out over time.
• Put lubricating oil or grease on hydraulic components of the Mini Stepper
Master and any of its moving parts at 3 month intervals. Applying
lubricating grease may help to minimize noise and to fix uneven or rough
movements of the pedals, should these occur.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2016 Wagan Corporation. All Rights Reserved.
*,
2