Wagan Tech Mini Stepper Master Manual De Usuario página 4

Mini Stepper Master
• Store the Mini Stepper Master in a cool and dry environment.
• Do not clean the surface of the Mini Stepper Master with organic solvents
(i.e. gasoline, benzene, etc.) to avoid damaging the equipment's surfaces.
TENSION ADJUSTMENT
1. Locate the tension knob, which looks like a screw with a triangular cap
(Figure 1).
2. Locate the threaded hole on the backside of the main frame (3), opposite
of the pedals (Figure 2).
Figure 1
3. Twist the tension knob slowly into the threaded hole (Figure 3). As the
tension knob is fastened into the main frame, the amount of force required
to tighten the knob will increase.
4. Tighten the tension knob fully for the initial set up. One side of the stepper
will automatically lift up as the tension knob is screwed into the main
frame. Manually press one pedal all the way down and lift the other
pedal all the way up.
5. Once the tension knob has been inserted fully, test out the workout tracker.
First, reset the display by holding down the red mode button for about 4
seconds, then start stepping on each pedal in an alternating fashion to
make sure the workout tracker is counting.
6. If the tension is too tight or hard, adjust the knob by unscrewing it slightly.
Do not unscrew the tension knob too far out or you may have to repeat
the set-up process.
USING THE MINI STEPPER MASTER
We recommend that you utilize your Mini Stepper Master on a daily basis, for
half an hour at a time. We believe you will feel its marvelous cardio training
effects after one month of use. The Mini Stepper Master is excellent whether
3
by Wagan Tech
™
Figure 2
www.wagan.com
®
Figure 3