Cleaning And Maintenance; Environmental Protection - Würth VSG 48 DB Traducción Del Manual De Instrucciones De Servicio Original

Operation (fig. II)
Insert the screw belt [10] through the guide
■
rail [8] into the belt guide [9] as shown in the
illustration until the first screw has reached the
position FIRST.
Switch the screwdriver [2] to continuous opera-
■
tion and CLOCKWISE ROTATION.
Press the device against the workpiece to be
■
processed.
Always hold the device at a right angle against
the working surface.
3 The screw engages into the bit and is driven into
the workpiece.
When the motor coupling disengages, remove
■
the device from the workpiece.
Note
The tool has been set at the factory for
a screw length of 20 mm, the setting
"25" on the scale [11] must not be
changed.
Adjusting the length of engagement
The length of engagement can be set by turning the
adjustment ring [7]:
Turn the adjustment ring [7] in accordance with
■
the mark.
With each click the length of engagement is
changed by 0.38 mm.

Cleaning and maintenance

Important!
The device may only be cleaned with
the mains plug disconnected.
Note
Technical information to help the user.
When this information is ignored, dam-
age to property may result!
Rapair work may only be carried out
by qualified persons using genuine
Würth spare parts.
During cleaning and maintenance
work, always use your personal safety
equipment such as protective glasses,
gloves and breathing mask.
Daily: Check the device for damage and blow
clean using compressed air.

Environmental protection

Do not dispose of the device with
domestic waste. Dispose of the
device only via an authorized waste
management company or your
municipal waste management
organisation. Adhere also to the
applicable regulations. In case of
doubt contact your waste management organisa-
tion. Recycle all packaging material in an environ-
mentally friendly manner.
9