Operation; Installing/Removing The Battery Pack - Ego Power+ PPX1000 Manual Del Usuario

OPERATION

WARNING:
Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
marked to comply with ANSI Z87.1. Failure to do so could result in objects being
thrown into your eyes and other possible serious injuries.
WARNING:
by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.

INSTALLING/REMOVING THE BATTERY PACK

WARNING:
assembling parts, making adjustments, cleaning, or when not in use. Removing
the battery pack will prevent accidental starting that could cause serious personal
injury.
NOTE: Fully charge the battery pack before first use.
To install battery pack (Fig. 5)
1. Align the ribs of the battery pack
with the mounting slots in the
telescopic power pole's battery port.
2. Press the battery pack towards the
telescopic power pole until it snaps
into position.
NOTE: Make sure that the latch on the
bottom of the battery pack snaps in
place and the battery pack is secured to the telescopic power pole before beginning
operation. Failure to securely seat the battery pack could cause the battery pack to fall
out, resulting in serious personal injury.
16
56-VOLT LITHIUM-ION TELESCOPIC POWER POLE — PPX1000/PPX1000-FC
Do not allow familiarity with this product to make you careless.
Always wear safety goggles or safety glasses with side shield
Do not use any attachments or accessories not recommended
Always remove the battery pack from the product when you are
5
Mounting Slot
Rib