Hisense DH16 Guía De Uso Y Cuidado página 15

Specific electrical requirements are listed in the chart below.
Follow the requirements for the type of plug on the power
supply cord.
Power Supply Requirements
■ 220-240V ~ / 50Hz
■ 15A time-delay fuse or circuit breaker
To reduce the risk of injury to persons, malfunction, or damage to the product or
property when using this appliance, follow basic safety precautions, including the following:
NOTE:
Your model may differ from the one shown.
A
A
A. 12" to 18" (30.5cm to 45.7cm)
Recommended Grounding Method
This dehumidifier must be grounded. This
dehumidifier is equipped with a power supply
cord with a three-prong grounding plug. The
cord must be plugged into a mating, grounded
three-prong outlet, grounded in accordance
with all local codes and ordinances. If a mating
outlet is not available, it is the customer's
responsibility to have a properly grounded
three-prong outlet installed by a qualified
electrician.
It is the customer's responsibility:
■ To contact a qualified electrical installer.
■ To assure that the electrical installation is
■ Do not locate outdoors. This dehumidifier is intended for indoor,
residential use only. This dehumidifier is not recommended for
commercial use.
■ Allow at least 12" to 18" (30.5 cm to 45.7 cm) of space on the rear
and sides of the dehumidifier for models with back louver and
above the dehumidifier for models with top louvers.
■ You will need a surface strong enough to support the
dehumidifier when its bucket is full of water.
■ You will need a surface level enough to keep the water from
spilling when the bucket is full of water.
■ Do not block the louvers of the unit .
■ Never operate this dehumidifier in an area that is likely to
accumulate standing water. If this condition develops, for your
safety disconnect the power supply before stepping into the
water.
12
adequate and conforms to the Nation
Electrical Code, ANSI/NFPA 70-last edition,
and all local codes and ordinances.