Cleaning And Maintenance - FIRST AUSTRIA FA-8120 Manual De Instrucciones

HEATING BLANKET
IMPORTANT INSTRUCTIONS RETAIN
FOR FUTURE USE
You arE stronglY rEcoMMEndEd to
rEad thE instructions and Warnings
hErEin BEForE using thE EQuipMEnt
and to kEEp thE BooklEt in a saFE
placE.
GENERAL WARNINGS
it may cause bodily injury or loss of property
if you misuse the blanket or do not operate it
according to the instructions.
• Read the instructions.
• Do not use folded.
• Do not use rucked.
• Do not insert pins.
• Do not tuck in.
• Do not use if wet.
• Do not use with a helpless person, an
infant or a person insensitive to heat.
• This appliance is not intended for medical
use in hospitals.
• Do not use on a adjustable bed, or if used on
an adjustable bed, check that the blanket or
cord cannot become trapped or rucked.
• This blanket is not to be used by young
children unless the controls have been
preset by adults or guardian, or unless the
child has been adequately instructed on
how to operate the controls safely.
• Use only with the control unit that comes
with the blanket.
• Do not dry clean.
• Do not use together with other heating
appliances.
• Do not try to repair a fuse link or thermal
link. the appliance must be returned to the
manufacturer or his agent if the link has
ruptured.
• Examine the appliance frequently for signs
of wear or damage. If there are such signs
or if the appliance has been misused, return
it to the supplier prior to any further use.
• Avoid creasing the appliance.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
SPECIAL WARNINGS
A potentially dangerous situation which may
result in death or serious injury if the warning is
disregarded.
2
• Do not use this product if the plug,
connector, wire, etc. are damaged or the
outlet is loose. Electric shock or fire may
result.
• Do not pull the flower code to plug or
unplug and do not touch with wet hand.
Electric shock or fire may result.
• Do not pull or lift the power code when
you move or transport the product. lift the
entire matt to transport or move. The worn
electric cord may lead to fire.
• Make sure that the thermostat is
completely inserted into the heating pad.
If the thermostat is loosely inserted, electric
spark may result in the connected area,
causing the electric shock or fire.
• The temperature may rise a lot due to
the heat storage effect if time passes by
even when the low temperature was set,
because the thermostat is an indirect
adjustment system that controls the input
of electric current.
Be specially careful of heat burn injury, electric
leakage, and fire when you use this product for
a long time. Make sure that you unplug it when
you go out or do not use it. attEntion! the
insulation heat storage may cause the electrical
shock, electric leakage and fire. Do not keep
the product on when you do not use it or go out.
attEntion! Overheating may result in fire.
PARTS OF THE DEVICE
[Fig. a]
1. heating blanket
2. control panel
3. Detachable power cable
4. Led light of power and temperature level
indicator
5. temperature level selector
OPERATING INSTRUCTIONS
LAYING THE ELECTRIC HEATING BLANKET
the electrical heating blanket should be laid on
a relatively hard un unadjustable mattress.
The blanket body should be laid flat from
shoulder to feet when sleeping.
the electric heating blanket can be spread
either on the front side or the back side.
The side with the switch should be placed near
the shoulder for the convenient operation.
The four clasp on the corners should be fixed
tightly to the mattres of the bed after you ley
the electric heating blanket to prevent the
blanket from moving or creasing. (the creased
parts tends to cause high temperature which is
very dangerous).
In order to keep the electric heating blanket flat
and clean and to reduce the abrasion, please
cover the blanket with sheet for use. (Do not
cover it with blanket or cotton mat, which will
prevent the balnket from transmitting heat).
OPERATION OF THE ELECTRIC HEATING
BLANKET WHILE USING
please pre-heat the electric heating blanket
for 30 minutes to 1 hour before using. plug in
the blanket to the power supply and make sure
they are connected firmly. Select the proper
temperature level (high, middle or low) by
selector. Set the switch to high level and the
blanket will warm up soon. For all night use of
the electric heating blanket, you should pre-set
the switch to low level before sleeping in order
to avoid the risk of heatstroke. Please switch
off the blanket when you do not need heating.
The switch of the blanket should be exposed to
the air. Do not cover it with quilt or pillow and
please avoid pressure on it.
AFTER USE, PLEASE SWITCH OFF THE
BLANKET AFTER YOU GET UP AND
THEN UNPLUG THE BLANKET FROM THE
POWER SUPPLY.

CLEANING AND MAINTENANCE

Machine washing of the blanket is possible;
however, hand washing/wiping it down will
prolong the life of the blanket. to machine
wash, remove the controller and place the
blanket in a net bag and seal it. use a small
amount of detergent and set the washing
machine to a „Delicate Wash" with a maximum
temperature of 40°. When washed, remove the
blanket from the net bag and drape it over a
clothes line to dry. do not use clothes pegs to
secure it.
Maintenance of the power cord of the
switch.
Plase clean the surface with neutral detergent
when it is dirty and wipe it dry with soft cloth.
Do not clean it with industrial solvent like
benzene or kerosene.
WHEN NOT IN USE, STORE AS FOLLOWS:
CAUTION FOR STORAGE
store electric heating blanket only if it is dry.
it should be hanged at a ventilated location to
dry naturally.
Do not connect the balnket to power supply to
dry it.
So not dry in the sun or iron it, which will cause
safety problems because of the aging of the
insulating layer.
3
the dry electric heating blanket should be
folded without any crease.
do not place it under quilt or other things in
order to avoid any pressure.
Do not use mothproofing agent like naphtalene,
which will damage the insulation material.
SPECIAL SITUATIONS
If any of the following situations occurs:
1) The red LED indicator does not come on:
check it is plugged into the power socket.
2) if the problem cannot be resolved by the
aforesaid procedures, stop using this
product immediately and contact after-sales
center or sales ahop where you bought it.
TECHNICAL FEATURES
Voltage 220-240V ac 50hz
FA-8120: 55-60W
FA-8122: 2 x (55-60W)
temperature 30-50ºc
3 temperature settings: 30ºC, 40ºC, 50ºC
this product is meant for domestic use.
The conformity, certified by the CE-marking on
the device, refers to the ECC Directive 2004/108
on electromagnetic compatibility and to the EEc
directive 2006/95 on electric material destined to be
used within given voltage limits.
This product is an electronic device that was tested to
assure, according to the current technical knowledge,
that it does not interfere with other nerby located
equipment (electromagnetic compatibility) and that it
is safe if used according to the advices given in the
instructions for use. In case of operation anomalies,
do not keep using the device and, if necessary, refer
to the manufacturer directly.
DISPOSAL PROCEDURE (DIR. 2002/96/EC
– WEEEE)
the symbol on the bottom of the device indicates
the separated collection of electric and electronic
equipment. At the end of life of the device, do not
dispose it as mixed solid municipal waste, but dispose
it referring to a specific collection centre located
in your area or returning it to the distributor, when
buying a new device of the same type to be used
with the same functions. This procedure of separated
collection of electric and electronic devices is carried
out forecasting an European environmental policy
aiming at safeguarding, protecting and improving
environment quality, as well as avoiding potential
effects on human health due to the presence of
hazardous substances in such equipment or to an
improper use of the same or of parts of the same.
Caution! The wrong disposal of electric and electronic
equipment may involve sanctions.