Publicidad
Idiomas disponibles
Idiomas disponibles
1. Load a cassette as shown in Fig. 6.
2. Press the reset button to set the counter
3. Use the DICT/CONF switch to select
4. Set the VAS switch to ON or OFF.
5. Press the REC button. (The PLAY but-
6. Press and hold the CUE INDEX button for at least 3 sec-
7. Press the STOP button to stop recording.
TRC-970C_US
to "000". The counter shows relative
tape position.
the recording mode.
DICT: Recording dictation
CONF: Recording conferences
ton is engaged simultaneously.)
VAS ON: Voice activated recording
When you talk, the unit will start recording. When you
stop talking for as long as 4 to 8 seconds, the unit will
stop recording (variations in voice level do not stop
recording).
Use the VOLUME control to adjust the microphone sen-
sitivity to your voice. If voices are not activating recording,
increase the volume. If recording does not stop when
talking stops, decrease volume.
NOTE: If the first few words you speak activate record-
ing but are not recorded, say an extra word to start re-
cording before you dictate. (For important recordings,
set the VAS switch to OFF.)
VAS OFF: Standard recording
Recording will continue until the STOP button is pressed.
onds to mark important segments of the recording. The
unit records an index tone on the tape. Release the CUE
INDEX butto to resume recording.
•
An index tone can heard when the tape is played back.
6
-E5-
Fig. 6
25/03/2004, 12:05
Publicidad
