LGB 65006 Manual De Instrucciones página 8

This kit is designed to convert 2x52x series LGB models
to sound. All of the parts required for installation are
included with this kit. Despite this, we must point out
that this installation assumes you have electrical and
mechanical knowledge about model railroading. We
assume no liability for mistakes or damages caused by
improper installation.
This sound kit can also be used with the 65011 standing
sounds power supply. The horn and the whistle can also
be activated by means of a reed switch (69800, 65012).
The connections for this can be found in Figure 4.
8
Contents
This kit consists of the following parts:
• "Sound module" circuit board
• Speaker
• "Volume controller and mode of operation switch"
circuit board
• Cable for voltage supply
• 6 each mounting screws & 4 each spacers
1 x 1 x
2 x 4 x
1 x
4 x
1 x