HIKVISION DS-PKFS-4 Manual De Instrucciones

DS-PD2-T12P-WEL
DS-PKFS-4
12m Wireless Outdoor Detector
Two Way Wireless Keyfob
EN50131-3:2009
EN50131-5-3:2005+A1:2008
Security Grade (SG) 2
Environmental Class (EC) II
E N G L I S H
Diagram References
1 REGISTERING FROM DEFAULT
Registering the keyfob is performed in the Manager Menu of the
Control Panel.
2 LEDs
1) General LEDs:
(i) From power up: Not Register. (ii) Registering process.
(iii) 8 x flashes: Register.
(iv) Fast flashing: Unlocking. (v) Fast flashing: Locking.
(vi) 18 x Slow flashes (10 secs): Fault with new battery installed.
(vii) 6 x Flashes: Alarm (when checking status)
2) Arming/Disarming LEDs:
(i) Arming.
(ii) (Amber) 4 x Flashes: Fault, 1 x Flash: Key pressed.
(iii) Armed. (iv) Disarmed.
3 REPLACING THE BATTERY
When the battery needs replacing please make sure that the
positive and negative are as shown in the diagram.
Technical Specification
Button Configurations (all programmable):
Button Actions:
Show status, Arm/Set area, Disarm/Set area, Latch output, Timed
output and Personal Attack.
Battery:
Type: 1x Li-Mn Cell 3.0V
Part Code: BATT-KF1215
Threshold: 2.1V +/- 5% at 25°C. Life: Up to 2 Years.
Wireless:
Transmission Frequency: FM Transceiver Narrow Band.
Transmission Method: Fully encrypted rolling code
Code combinations: 4294967295.
Materials and Environment:
Indication: LEDs (Red, Green, Amber)
Operation Temperature:-10°C to 40°C(Certified)
Dimensions (H x W x D): 72 x 30 x 20mm.
Weight: 28g
Compatible with the Enforcer, PCX and EURO commercial control
panels (using the Wireless Expander).
Battery Information
The batteries supplied have been chosen to provide long service life whilst,
for safety reasons, having limited output current.The battery is protected
on purchase by a piece of plastic that must be removed for operation.
When disposing of the product, the battery must be removed and disposed
of separately in accordance with the local regulations.
This product and - if applicable - the supplied accessories too are marked
with "CE" and comply therefore with theapplicable harmonized European
standards listed underthe RE Directive 2014/53/EU, the RoHS Directive
2011/65/EU.
For electrical products sold within the European
Community. At the end of the electrical products
life, it should not be disposed of with household
waste. Pleaserecycle where facilities exist.
Check with your local Authority or retailer for
recycling advice in your country.
1
REGISTERING FROM DEFAULT
2
LEDs
1) General LEDs
G
(i) From power up:
Not learnt
R
(slow flashing)
R (v) Fast flashing: Locking
2) Arming/Disarming LEDs
G (i) Arming
3
REPLACING THE BATTERY
G
>5s
R
G
(ii) Learning process
(fast flashing)
R
(vi) 18 x Slow flashes (10 secs):
R
Fault with new battery installed
(ii) (Amber)
O 4 x Flashes: Fault
1 x Flash: Key pressed
2
1
R=Red G=Green O=Orange
G
R
G
(iii) 8 x flashes: Learnt
G
(iv) Fast flashing: Unlocking
R
(vii) 6 x Flashes: Alarm
(when checking status)
G
R
(iii) Armed
4
3
+
-
BATT-KF1215
(iv) Disarmed