GRAPHITE 58G200 Manual Del Usuario página 10

TRANSLATION OF ORIGINAL INSTRUCTION
NOTE: BEFORE USING THE APPLIANCE, CAREFULLY READ THESE INSTRUCTIONS AND RETAIN THEM FOR
FUTURE REFERENCE.
WARNING: SAFETY REGULATIONS MUST BE OBSERVED, WHEN THE DEVICE IS OPERATED. THIS INSTRUC-
TION MANUAL AND GENERAL SAFETY INFORMATION SHOULD BE READ FOR YOUR OWN AND BYSTAN-
DERS' SAFETY, BEFORE THE TOOL IS OPERATED. THIS INSTRUCTION MANUAL SHOULD BE KEPT FOR FU-
TURE REFERENCE.
THE HEATER IS NOT INTENDED TO BE USED BY PEOPLE (INCLUDING CHILDREN) WITH LIMITED PHYSICAL,
SENSORY OR MENTAL ABILITIES, OR BY PEOPLE WITHOUT EXPERIENCE OR KNOWLEDGE OF THE EQU-
IPMENT, UNLESS UNDER SUPERVISION OR IN CONFORMITY WITH THE INSTRUCTION MANUAL OF THE
EQUIPMENT PROVIDED BY PEOPLE RESPONSIBLE BY THEIR SAFETY.
DESPITE USING THE CONSTRUCTION, WHICH IS SAFE BY DESIGN ITSELF, PROTECTION MEANS AND AD-
DITIONAL SAFETY FEATURES, THERE IS ALWAYS A RESIDUAL RISK OF INJURIES DURING OPERATION.
WARNING:
Children under 3 years of age should be kept away from the heater, unless under constant supervision.
Children from 3 to 8 years of age are allowed to switch the heater on and off under supervision of adults.
The heater must be placed or installed in the permissible position. At the same time, the heater must not by
adjusted, cleaned or connected by children.
NOTE – Some parts of the heater can be very hot and cause burns. Protect children against burning.
Do not use the heater to avoid overheating.
●
Do not use external controllers (programmators, timers) or other devices to automatically switch on the
heater.
●
Do not use the heater in the immediate vicinity of a bathtub, shower or a swimming pool.
The heater is intended to be used in closed rooms, such as shops, warehouses and residential rooms.
SAFETY CONDITIONS
●
The heater should be used indoors only and away from flammable materials.
●
The minimum safety distance is 2 m from flammable materials and 1 m from walls and other objects.
Failure to observe this condition may cause fire.
●
Do not use the heater in dusty rooms and where petrol, solvents, paints or other evaporating materials
are stored. Operation of the device may cause ignition or explosion of these substances.
●
The device should be position at the minimum distance of 15 cm from a wall to ensure proper air flow.
●
If the temperature limiter switches off during operating, a cause of overheating should be eliminated,
before the device is used again, e.g. a restricted inflow or outflow of air, clogged fan.
●
Do not use the heater without guards.
●
The outlet opening should not be reduced or covered.
●
The heater must always be disconnected from the power supply before maintenance or repair.
●
Note! Do not place the heater on flammable surfaces during operation.
●
Make sure the air inlet grate and outlet grate are passable and are not covered.
●
Do not unplug the power cord, before the heater is switched off.
●
Protect the power cord against high temperature, chemicals and mechanical damages.
●
Use sockets with protection pin only.
NOTE!
The heater should be repaired by specialised workshops.
ELECTRIC HEATER
58G200
DETAILED SAFETY REGULATIONS
10