Kalorik TKG HVC 1001 Manual Del Usuario página 6

(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
ASSEMBLING THE CORDLESS VACUUM CLEANER
Note: Ensure that the handheld vacuum cleaner is not connected to the
charger before assembling the extended tube.
1. Unpack the device and all its accessories.
2. Insert the tube into the suction mouth of the vacuum cleaner until you
hear a "click".
3. Connect the turbo brush to the extension tube. Make sure all parts are
properly installed before using the vacuum cleaner.
REMOVING THE EXTENSION TUBE AND ACCESSORIES
1. To remove the extension tube, press the tube release button on the
vacuum cleaner.
2. Remove the tube by pulling it gently while holding the vacuum handle.
Note: Ensure that the unit is not connected to the charger before detaching
the handheld vacuum cleaner.
USING THE CHARGING STATION
The charging station can be mounted on a wall or used on the floor. Small
accessories can be stored on the station:
To charge the vacuum cleaner, connect the charger to the charging socket.
The battery status light flashes to indicate that the vacuum cleaner is connected
to the charger and the device is charging. When fully charged, the 3 LEDs go off,
approximately 10 hours after full charge.
USING THE HANDHELD VACUUM CLEANER
Note : Please take the vacuum out from the charger before use. If the vacuum cleaner is
charging or in low battery status, the vacuum cleaner will not work.
Place the connector tube on the suction port and then the 2-in-1 nozzle or the soft brush.

Press the On / Off - Power switch to select between (I) Normal Power, (II) Maximum Power

or Off.
USING THE UPRIGHT VACUUM CLEANER
Note : Please take the vacuum out from the charger before use. If the vacuum cleaner is
charging or in low battery status, the vacuum cleaner will not work.
• Make sure you have properly connected the extension tube and turbo brush.
• Press the On / Off - Power Dimmer switch to toggle between (I) Normal Power, (II) Maximum
Power or Off.
6
HVC1001-180912