Safco TASK MASTER 5100 Instrucciones De Ensamblaje página 2

STOOL ADJUSTMENT INSTRUCTIONS
o
o
Thank you for purchasing this Safco
product. In order to make any warranty
claim, it is necessary to complete and
return the enclosed warranty
registration within 30 days of purchase.
Due to continual upgrading of our
products, photographs or illustrations
may not reflect actual (exact)
appearance of product.
MAINTENANCE
The pneumatic lift in the Cylinder is permanently lubricated
at the factory and needs no further lubrication. NEVER
LUBRICATE THE PNEUMATIC LIFT. Do not remove clip
from bottom of Cylinder. Contact Safco immediately if clip
is missing or damaged. Clean polyurethane seat and back
with soap and water. To repair small cuts in polyurethane,
apply a few drops of quick-drying glue into the cut and
press the sides together until the glue sets.
GENERAL SAFETY INSTRUCTIONS
Do not stand on seat.
Chair must be on level surface to ensure proper stability.
Only use chair when fully assembled.
Never use chair if it does not perform according to this
sheet or warranty may be void.
Immediately report any problems to Safco and always
give the manufacturer’s date code information from the
label under the seat.