Maintenance; 22 7.1 Calibration/Adjustment; Cleaning; Disposal - Dräger SCANIA Interlock 7x00 Serie Instrucciones De Uso

|

Maintenance

7 Maintenance
7.1 Calibration/adjustment
● Only by an authorized Dräger Interlock service centre.
● Check calibration at least every 12 months.
● Once the service interval expires, the display shows the message Service
required in X days.
● If the unit is not serviced, the vehicle can nevertheless be started during a
transition period of several days (dependent on the configured parameters).
7.2

Cleaning

● To clean, wipe with a disposable tissue.
● Do not submerge in liquid – liquid must not enter the sockets!
For information on suitable cleaning agents and disinfectants and their
specifications, see document 9100081 at www.draeger.com/IFU .
8

Disposal

Dispose of the product in accordance with the applicable rules and regulations.
This product must not be disposed of as household waste. This is indi-
cated by the adjacent symbol.
You can return this product to Dräger free of charge. For information
please contact the national marketing organizations or Dräger.
9

Technical data

Measuring principle Electrochemical DrägerSensor
Measuring range up to 3.0 mg/L
30
Ambient conditions
for operation and storage -40 to 85 °C
20 to 98 % rel. hum.
600 to 1100 hPa
No influence of changes in altitude on the
measurement result
Sensitivity drift typically 1 % of measured value/month
Display Display
Calibration interval typically 12 months
Dimensions (H x W x D)
Handset approx. 138 mm x 61 mm x 36 mm
Control unit approx. 148 mm x 90 mm x 32 mm
Weight
Handset approx. 240 g
Control unit approx. 240 g
Voltage supply 12 to 24 V
Power consumption
maximum <2.5 A
stand-by <1 mA
Switch relay for the lead for the starter relay
continuous <16 A
peak <40 A
Output relay
switchable de-energized 48 V
switchable energized 24 V
Instructions for use | ®
SCANIA Interlock 7x00