HQ PURE600/12 Manual Del Uso página 5

Inversor de onda sinusoidal pura de 600 vatios cc a ca
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
6.
The inverter chassis should be connected to earth by using the earth lug. The earth
point will vary depending on where the inverter is installed. In a vehicle, connect
chassis ground to chassis of the vehicle. In a boat, connect to the boat's ground
system. In a fi xed location, connect to earth.
Troubleshooting
If the inverter doesn't function properly, there can be several possible reasons for it:
1) Poor contact
• Clean contact parts thoroughly
2) Inverter has no power
• Check car fuse, replace damaged fuse
• Check connection of wires
3) Fuse is blown
• The fuse is located in the DC (cigarette) plug. Replace the fuse with a similar
fuse of equivalent value
4) AC output shutdown caused by overload
• Make sure the continuous load of the attached appliances does not exceed 600
Watts
5) AC output shutdown caused by overheating
• Under heavy loads for extended periods of time, the inverter will shutdown the
output to prevent damage from excess heat. If this happens, please proceed as
below:
(A) Switch off the power switch of the inverter
(B) Decrease load of the machine i.e. disconnect some of the appliances or wait
until this inverter cools down.
(C) Switch on the power switch of the inverter.
6) Low-battery shutdown
• Recharge your battery and resume operation.
Caution!
Always place the inverter in an environment that is:
1. Well ventilated
2. Not exposed to direct sunlight or heat source
3. Out of reach from children
4. Away from water, moisture, oil or grease
Away from any infl ammable substances
CHASSIS
GROUND
LUG
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pure600/24Pure600/12 fPure600/24 f

Tabla de contenido