happybrush HBR2 Manual Del Usuario página 6

10
• Only use the toothbrush with
the provided power supply
and charging station.
Danger of Electric Shock from Water!
• Never immerse the charging station, mains
cable or mains plug in water or other
liquids and ensure that these components
cannot fall into water or become wet.
• Use the charging station only in closed
rooms.
• Should the charging station fall into water,
cut off the power supply immediately.
Never attempt to pull the charging station
out of the water while it is still connected
to the mains power!
• Never touch the charging station, mains
cable or mains plug with wet hands when
these components are connected to the
mains power.
Risk of Damage to Material and Property
• Position the mains cable in such a way
that it does not become squashed or
bent and does not come into contact
with hot surfaces.
• Remove the mains plug from the plug
socket if a fault occurs during charging
or before a thunderstorm.
• When you pull it out of the plug socket,
always pull on the mains plug and never
the mains cable!
Warning of fire!
• Do not use the device in rooms
containing easily ignitable dust or
poisonous and explosive fumes.
• Do not cover the charging station during
charging.
The Proper Handling of the Battery
• If the battery has leaked, do not allow
your skin, eyes and mucous membranes
to come into contact with the battery
acid. If you touch battery acid, rinse the
affected area with abundant fresh water
immediately and contact a doctor as
soon as possible.
• The battery must not be taken apart,
thrown into a fire, immersed in liquids or
short-circuited.
PREPARATION AND INSTRUCTIONS
CHARGING
1. Plug your charging station into the power mains.
2. Pop your happybrush onto the charging station. A
complete charge of the battery takes approx. 16
hours. A pulsating LED bar indicates that charging is in
progress. Charging is complete when all the LEDs light
up permanently. It is normal for the handle to become
warm during charging.
Important: Charging is done inductively and can be affected
by metallic objects near the charging station. Keep at
least 10 cm between the charging station and any metallic
objects.
BRUSH HEADS
Push the brush head onto the metal tip of the handle until it
sits firmly.
BRUSHING INSTRUCTIONS
1. Moisten my bristles with a bit of water and then apply
toothpaste - happybrush toothpaste works best. Now
you can start brushing!
2. Place my brush head against the outer surface of your
teeth and slowly move me along the gum line from
tooth to tooth, holding the brush head against each
tooth for a few seconds.
3. Repeat this procedure on the insides of your teeth
and the chewing surfaces. Begin at the end of the
upper arch and then move me along the lower arch.
4. Pamper the inner surfaces of your canine teeth and
the rear surfaces of your molars. At the end of 2
minutes, the regular cleaning cycle is finished and you
can polish areas with discolouration.
CLEANING
HANDLE
1. Take the brush head off and rinse the metal tip with
warm water. Please do not try to clean around the
seal of the metal tip with a sharp object because it
could damage the seal.
2. Now, simply wipe the handle with a dry cloth.
BRUSH HEAD
1. Rinse the brush head and bristles under running
water after every use. Then just shake excess water
off the brush head.
2. Remove the brush head from the toothbrush
at least once a week and clean the connection
between the handle and the brush head with warm
water.
3. Use a new brush head every 2-3 months for best
results. The indicator will tell you when: Simply
change it when the smile fades.
CHARGING STATION
1. Remove the plug from the mains socket before
cleaning the charging station.
2. Then wipe the charging station with a slightly damp
cloth.
Important: The handle, the brush heads, and the charging
station are not to be cleaned in the dishwasher. Do not
submerse the charging station in water. Do not use abrasive
cleaning agents. Also do not try to clean the charging
station with any kind of sharp metallic object or nylon
bristles.
11