Light Bulb Replacement - Maxx Cold MXM1 Serie Manual De Servicio

SWING DOOR REPLACEMENT AND ADJUSTMENT
1 Open the bottom shroud and hold the door, then loosen the bottom hinge's screws and take off
the old door
2 Prepare new door, insert top pin into top hinge, get one bottom hinge to hold the door by the
bottom pin, then fasten bottom hinge securely to the door frame with three screws;
3 Allow the door to freely swing, make sure it swings closed by itself with no restriction
4 Plug the unit in and make sure the lock works well;
5 If not, adjust the door height by adding the plastic spacer/washer provided to the bottom hinge
pin
SLIDING DOOR REPLACEMENT AND ADJUSTMENT
1 Take off the hook of counterweight of door from top of the door;
2 Hold the door up until it's bottom edge is over the bottom channel, move the door out across the
channel and lay the door down;
3 Prepare new door, hold the door insert into top channel until bottom edge is over the bottom
channel, move bottom of door across the channel wall and set it down in to the channel
REMOVE THE BOTTOM SHROUD
Loosen and remove the top screws, slide the shroud up and out

LIGHT BULB REPLACEMENT

1 Upper light bulb replacement: Loosen the screws in the bottom of top shroud, swing the top shroud
up until it is held by the top of the cabinet, now the light bulb can be replaced;
2 LED light bulb replacement: Take the cover off, then the LED bulb can be replaced
9