Oregon JW3800 Operación Manual página 10

*The chain may hang loose from the underside
of the bar when the unit is Horizontal (see
image below), this will be rectified later.
Next, we will attach the chain brake.
Before doing this we need to ensure that the
Chain Brake is disengaged, note the location
of the metal band in the images overleaf for
the correct position. If engaged pull back on
the Guard/Lever to Disengage an audible click
will be heard when done correctly .
(Please see the section at the end of the
guide Re: Chain brake removal)
The next step is to line the two holes on the chain
brake with the two brass retaining bolts on the
main unit. Once done, push the chain break in
place. You will notice that it does fully locate onto
the unit, as the locating lug on the chain brake
needs to be adjusted to fit into the corresponding
hole on the chain bar.
The Locating lug can be moved by turning the
adjustment screw on the chain brake, either
clockwise to move the locating lug, toward the
8