Power; Setup; Backlight - KING 900 Manual De Instrucciones

INSTRUCTION MANUAL

POWER

The transmitter is powered by AC adapter or internal batteries. To use
the AC adapter, insert the round plug of the adapter into the "12V"
external power receptacle on the transmitter panel and plug into a
wall outlet.
The transmitter uses 8 "D" (LR20) alkaline or rechargeable batteries
that are installed inside the transmitter battery compartment. Remove
the battery compartment cover to install the batteries.
The receiver is powered by a 9 Volt square (6LR61) alkaline battery.
To install this battery, remove the battery compartment cover located
on the back top portion of the receiver. Install the 9 Volt battery by
connecting it to the battery snap boot inside the battery compartment.
Replace the battery cover.
BATTERY CONDITION INDICATORS
There are battery indicator symbols on the left edge
of both the transmitter and receiver display panels.
These "fuel gauge" battery symbols will be solid when
full and reduce as the batteries are depleted.
TRANSMITTER DISPLAY
INDUCTIVE
CLAMP
JACK
EXTERNAL
POWER
JACK
I
6 KING INNOVATION
SELECTION
CONTROLS
DIRECT
CONNECT
LEAD
JACKS
ON/OFF
CONTROLS
MODE
CONTROLS
KING 900 TRANSMITTER
Press the power icon to display the home screen.
From the home screen you will be able to select
Setup, Broadcast/Clamp, or Direct Clip-On.
HOME
EXT
PWR
Broadcast Direct
or Clamp

Setup

Clip-On
SETUP
Select "Setup" from the main menu and use
the arrows to scroll through the following options:
• Power Down: allows the user to select the amount of time from turn
on that the unit will automatically shut down to save battery power.
POWER DOWN
ON, 15 MIN, 30 MIN, 60 MIN
• Battery: allows the user to adjust the KING 900 transmitter to be
used with either traditional alkaline batteries or rechargeable ones.
BATTERY
ALKALINE
RECHARGEABLE
• LCD Contrast: Regulates the light/dark ratio on the screen
CONTRAST
1 - 7
• LCD Backlight: sets levels of backlight brightness.

BACKLIGHT

1 - 4
• Pattern: allows users to select a solid tracing signal or a pulsating
one. Please be aware that the solid signal uses significantly more
battery power as the signal is continuously activated.
PATTERN
SOLID
BEEP BEEP
KING 900
I
KING INNOVATION 7