Product Information - TMC Aquarium Vecton 2 Manual De Instrucciones

Instructions for
Installation and Use
2
This V ecton unit is supplied with two universal hosetails for connecting the
steriliser to the water system. Installation is explained in detail below, but please
read the following safety information first.
Important Safety Information
- Never look directly at an illuminated UV lamp.
- Do not run this unit dry. Do not cover this unit.
- lways isolate the unit from mains electricity and turn off the
water supply before carrying out any maintenance.
- Power must be supplied through a Residual Current Device (RCD) with a
rated residual operating current not exceeding 30m .
- This unit must be earthed. Never use a fuse larger than 3 amps.
- Rating: 230V, 50Hz. Class 1. IPX4. US models: 120v 60Hz.
Model 200/G8T5: 15-17watts. Model 300/G16T5: 24-26 watts
Model 400/G15T8: 23-25watts. Model 600/G25T8: 36-38 watts
- The unit must not be submerged in water.
- If the quartz sleeve is cracked, replace it immediately.
- This unit is designed to be used indoors and is not suitable for
any outdoor applications.

Product Information

This unit is manufactured and conforms to:-
Safety: BS EN 60335-1: 2002. BS EN 60335-2-55: 2003
EMC: EN 55015: 2000. EN61000-3-2: 2000 EN61000-3-3: 1995
This unit is CE approved.
POSITIONING THE V
Caution: This unit must not be mounted above the aquarium or in any position
where it may accidentally fall into water or be splashed by water.
This unit must be mounted vertically using the key hole slots in the underside of the
base, as shown in the diagram below. It must not be mounted in any other plane.
Suitable for mounting on flammable surfaces.
CONNECTION TO THE QU RIUM W TER SUPPLY
Water flow: Water should be pumped into the lower inlet port and returned
to the aquarium via the upper outlet port as shown in the diagram above.
Connection with flexible hose
2
The V ecton unit is supplied with two universal hosetails to take
diameter flexible hose. If you are using one of the three larger sizes, the smaller
sections of the hosetails must be cut off to ensure sufficient water flow and to
prevent possible damage to the pump. We recommend that you use the largest
diameter hose available. s it is easier to cut the hosetails while they are attached to
the unit, attach them using the female threaded lock nuts and gaskets provided. Ensure
that the gaskets are seated correctly between the flat face of the hosetails and the flat
face of the inlet/outlet ports. Using a hacksaw, carefully cut off the excess hosetail,
ensuring that the sections are cut off at the second ridge and that the cut follows the
line of the ridge.
Gasket
Once trimmed, hand tighten the lock nuts to secure the hosetails to the inlet/outlet ports.
Do not use jointing compound or PTFE tape. Secure the hosepipe to the hosetail
with a stainless steel hose clip.
The hosetails supplied are made from a translucent material which will glow when the
unit is operating correctly. (NB. glow only visible in low levels of light.)
- Please Read Carefully
IN
CUT
CUT
LINE LINE
2 ECTON UNIT
OUT
Mount vertically
on a wall or
side of cabinet
CUT
LINE
1
D NGER
1 / 3 / 1 /
", ", 1"and 1
2 4
Lock Nut
"
4