Wiring Diagrams - JET J-A3816 Manual De Instrucciones De Operación Y Piezas

Figure 9 – Table Adjustment
Head Adjustment
Change the radial position of
the drill head only if the drill press base is
secured to the floor. Swinging the drill head
without the base being secured to the floor
will cause the drill press to become unstable
and tip over resulting in injury and/or
damage to the machine.
The radial position of the drill head can be
changed to accommodate the drilling of a hole
that may be offset from the center of the table.
Reposition the drill head by loosening the
locking handles and swinging the drill head to
the desired position. Then retighten the locking
handles.

Wiring Diagrams

Refer to Figure 5 for wiring information. The
drive motor is115/230 volt single phase or
220/440 volt three phase. Notice: When
converting machine voltage, it is necessary to
re-wire the LED display connection accordingly.
Refer to figure 10.
Figure 10
12