Introduction; Set-Up And Assembly; Securing The Base; Assembly - JET J-A3816 Manual De Instrucciones De Operación Y Piezas

Introduction

This manual includes
maintenance instructions for the JET 15-Inch
Vari-Speed Drill Presses, Models J-A3816, J-
A5816, and J-A5818. This manual also includes
parts listings and illustrations of replaceable
parts.
Refer to Figure 1 for key features of the drill
press.
Figure 1 – Drill Press Features

Set-up and Assembly

Securing the Base

The base of the drill press has four mounting
holes. The drill press should be level and rest
solidly on the floor. Place shims under the four
operating and
8
mounting holes in the base as required to level
the drill press.

Assembly

The Drill Press is shipped with the head in
lowered position. Follow these instructions to
assemble.
1. Figure 2: Loosen locking handle on head
and raise the head toward the top of the
column. NOTE: Use an assistant to help
raise the head. Re-tighten locking handle to
secure head in position.
Figure 2
2. Figure 3: Use a wrench to loosen the hex
screw on the head collar, and raise the head
collar until it is contacting the head. Firmly
tighten the screw on the head collar.
3. Figure 3: Loosen the set screw on the rack
ring and raise rack ring to allow clearance
for the rack. Re-tighten the set screw.
Figure 3