Publicidad
must have been recorded.
Step-1 Enable voice recognition function of your mobile and set the mobile to handsfree state.
Step-2 When no call is in progress, press and hold the answer/end button for 3 seconds until
you can hear beep sound from the headset.
Step-3 Speak out the name of the person you wish to call loudly.
7.6 Redial
Press + key 3 seconds and you can hear beep sound from the headset. Release the button and
the headset will dial the last dialed telephone number.
7.9 Adjust the earphone volume
Press the volume + key to increase or - to decrease the volume during a call.
7.11 Switch the call between mobile and headset
In call state, press and hold the answer/end key for about 3 seconds until there is beep sound
from headset. The call will be switched from headset to mobile or vice versa.
Note for Multi-link use: When the first phone (AG1) under making a call, another calling into
from the second phone which is also connected with the Bluetooth headset, press volume+
about 1.5 seconds will answer the call in from the second phone (AG2), and will hold for the
AG1's calling. press volume + 1.5 seconds will switch the calling between two phones. Short
press the power key will end the call of talking, meantime will connect to the hold phone.( some
phone will asking if you want to connect the phone or not ), press again the power key will
ending the call of talking.
8. LED Indication
Headset status
In idle state after paired
In coming call
Low battery
9. Specification
* Bluetooth Specification v2.1+EDR class 2
* Supports Bluetooth Headset and Hands-free Profile（HFP 1.5）
* RF Frequency Range: 2.402-2.480GHZ, 2.4G ISM band
* Radio Performance: Receive Sensitivity of -90dBm, TX Power Max 4dBm
* Frequency Response: 20 Hz - 20 KHz, Very high Signal to Noise Ratio (SNR):95 Db, Total
Harmonic Distortion (THD):0.1%,
* Rechargeable 80mAh Li-Polymer Battery
* Charger adapter Output: DC 5V&200mA
* Nominal charging time: Max 1.5- 2 hours
* Talk time: Up to 6 hours
* Standby time: Up to 120 hours
Bedienungsanleitung
LED Indication
Blue light flashes 1 time every 3 seconds
Blue light flashes twice every 2 seconds
Red light flashes 1 time every 15 seconds and
there is beep sound
(DE)
Publicidad
