Timex W-196 Manual Del Usuario

THANK YOU FOR PURCHASING YOUR TIMEX® WATCH.
EXTENDED WARRANTY
Available in U.S. only. Extend your warranty for an additional 4 years from date of purchase
for $5. You can pay with AMEX, Discover, Visa or MasterCard by calling 1 800-328-2677 during
normal business hours. Payment must be made within 30 days of purchase. Name, address,
telephone number, purchase date, and 5-digit model number required. You can also mail a
check for $5 to: Timex Extended Warranty, P.O. Box 1676, Dept. EF, Little Rock, AR 72203.
Please read instructions carefully to understand how to operate your Timex® watch. Your
model may not have all of the features described in this booklet.
NOTE: Watch is shipped with guard around CROWN. Remove guard and push CROWN in to
start.
Pull CROWN to MIDDLE position and turn until correct date appears. After setting date, pull
crown all the way out and turn until correct time is shown. Ensure correct AM/PM setting by
verifying that date changes at midnight, not noon. Push CROWN in when done. Adjust date
after months with fewer than 31 days.
Pull CROWN all the way out. Indicator hand should point to 12 o'clock. If it does not, press
either push button to move hand until it points to 12 o'clock. TIDE and TEMP push buttons
move hand clockwise and counterclockwise, respectively. Hold push button to move hand fast.
Push CROWN in when done.
Indicator hand shows either tide or temperature constantly. When temperature is shown, press
TIDE push button to select tide clock. Hand moves to low tide and then to current tide. When
tide is shown, press TEMP push button to select thermometer. Hand moves to beginning of
thermometer scale and then to current temperature.
For tide clock, indicator hand always rotates clockwise, so tide is rising when hand is pointing
left and falling when pointing right. Number of hours to next high/low tide is shown on tide
scale.
The primary factor in determining tides is moon position. Tide clock uses moon position to
predict high and low tides, which are 6 hours and 12.5 minutes apart.
Tides are also influenced by sun position and shape of shoreline, so tide clock cannot precisely
give times of high and low tides. Periodic adjustment may be necessary.
To set tide clock, pull CROWN to MIDDLE position. Press either push button to move hand to
current tide. TIDE and TEMP push buttons move hand clockwise and counterclockwise, respec-
tively. Push CROWN in when done.
For tide information, go to www.timex.com/expedition
When worn on wrist, thermometer reading is affected by body heat. For more accurate read-
ings, remove watch and put in shade for at least several minutes.
Watch can measure water temperature also, if submerged. Be sure to select temperature dis-
play before placing watch in water, as buttons should not be pressed with watch underwater.
Thermometer readings are taken every minute, and more frequently, if temperature is chang-
ing.
Press crown to illuminate watch face. Electrolumi-
nescent technology used in the INDIGLO® night-light illuminates entire watch face at night and
in low light conditions.
www.timex.com
W-196
311-095000
O V E R V I E W
INDICATOR HAND
TEMPERATURE SCALE
TEMP PUSH BUTTON
CROWN
TIDE PUSH BUTTON
TIDE SCALE
DATE
SET DATE AND TIME
I N D I C ATOR HAND A D J U S T M E N T
T I D E / T E M P E R ATURE SELECTION
TIDE CLOCK
T H E R M O M E T E R
INDIGLO® NIGHT- L I G H T
NA
MIDDLE
SET DATE
OUT
SET TIME