Publicidad
Idiomas disponibles
Idiomas disponibles
3. Redrill the holes with the 3/4" masonry bit to the depth
required for the anchors.
4. Insert the anchors into each hole and tap into the
hole with a mallet until flush with road surface.
5. Reposition the speed bump in its installation position.
Insert the bolt through washer and hole in the speed
bump. Tighten with an impact wrench or heavy
ratchet. Repeat for each hole in the speed bump.
PAGE 2 OF 6
INSTALLATION CONTINUED
1-800-295-5510
uline.com
CAUTION! Do not overtighten. Excessive
tightening may damage the speed bump.
0421 IH-2396
Publicidad
