Descargar Imprimir esta página

Lifetime BA-3060 Manual Del Propietário página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

Read the following step-by-step installation procedures before you begin.
THE INSTALLATION
(For step-by-step assembly of alcove system directly into pocket.)
1. Trial Fit Bathtub
Make sure bathtub is level
and all feet on the bathtub
are making firm contact
with the subfloor. It may be
necessary to shim under bath-
tub for best overall subfloor
contact.
Proper installation requires
that the bathtub be nested
into a bed of mortar-type
material (Quikrete). Improper
installation will void the
warranty.
Figure 2
2. Bathtub Clip Installation
Snap the six bathtub clips
onto the 1
1
" bathtub flange.
2
The clips are designed to
slide on the bathtub flange to
easily locate studs. See Figure
2 for proper bathtub clip loca-
tion.
Important:
Bathtub clips must be
installed on bathtub prior to
bathtub being inserted into
stud pocket.
Important:
NEVER install bathtub over open floor joists. The floor
surface should be solid and level.
Stud
Tub
A
Tub Clip
3. Final Fit Bathtub
Secure bathtub to studs by
attaching with large head
roofing nails through tub clip
holes (one nail per clip).
Water Testing
Before water testing bathtub,
remove all material from bath-
tub including the plastic
liner/protector.
Figure 3
Back Panel
Bathtub
Flange
Wall Tabs
Bathtub
Slots
Cut-away view
Bathtub and Back Panel
4. Back Panel
Set the back panel into place.
Be sure that the wall tabs fit
into the bathtub slots. The
bathtub slots are located on
the back ledge of the bathtub.
The back panel must fit firmly
down onto the tub ledge. So
that you may proceed to the
next step, temporarily secure
the back panel with a nail
bent over the flange.

Publicidad

loading