Publicidad
Idiomas disponibles
Idiomas disponibles
TM
Veritek
Natural Gloss
Composite
Back Panel
Side
Panel
Wall Mounting
Knob
Wall
Mounting Clip
Receiving
Channel
5. Choose either the right or
left side panel, whichever
DOES NOT require plumbing.
Each side panel has three wall
mounting knobs which inter-
lock with the companion fac-
tory installed wall mounting
clip. The side panel must be
positioned so that the wall
mounting knobs slide into,
and interlock with, the wall
mounting clips. To accommo-
date this initial fit, raise the
side panel approximately one
to two inches above the back
panel.
M
NOTE: It is suggested that the filler spout and valve be located
within the area indicated in figure above. Use a drill and a hole
cutting bit, or a hole saw to cut your holes per manufacturer's rec-
ommendations. Drill or cut from the finished side of panel. For
best results, place a scrap of wood beneath hole to be cut. Trial fit
using the same procedures as the other side panel.
The Swan Corporation
One City Centre
Bath Alcove Walls
Receiving
Channel
Side Panel
M
Receiving Channel
Side Panel
6. Locate the side panel into
the receiving channel and
slide side panel down.
9. Measure location of plumb-
ing outlets (valves, tub spout,
and shower arm) from a line
straight up from front edge of
tub and height above top
ledge of the bathtub. We sug-
gest that you make a tem-
plate from cardboard to help
position your side panel over
plumbing outlets. Transfer
measurements to panel.
Suite 2300
St. Louis, MO 63101
Wall
Mounting
Knob
Wall
Mounting
Clip
7. The wall mounting knobs
of the side panel will interlock
with the wall mounting clips
of the back panel.
Final Fit
Anchor the side panels by drilling a 3/16" pilot hole through
each vertical and horizontal flange on both side panels. Use
drywall screws to secure side panels to the studs.
To achieve a tight fit along the back wall, it may be necessary
to shim between back wall and stud wall. Drill a 3/16" pilot
hole through the horizontal flange on back wall. Secure back
panel with drywall screws.
Care and Cleaning
This product is made of Veritek, a Natural Gloss Composite.
Finish is stain resistant; however, the finish requires reasonable
care. Wash regularly with warm water; use soft cloth with mild
liquid detergent such as Top Job, Ajax Liquid Cleaner, or
Mr. Clean All-Purpose Cleaner. Remove hard water stains or
mineral build up with scale removers such as Lime-Away. Never
use abrasive scouring powders, cleaners or pads. They will dull
the finish. Protect finish with any fiberglass wax or automotive
paste wax.
800-325-7008
Side
Panel
Bathtub
Ledge
Back
Wall
8. The lower outside edge of
the side panel must fit flush
against the top ledge of the
bathtub. The upper inside fit
of side panel to back wall
must also be flush. It may be
necessary to remove the nail
which was bent over the back
wall flange for temporary sup-
port.
FORM #456-3-05-5M
Publicidad
