Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS FOR MODELS: DWMIIIFS
Disconnect tool from air supply before attempting any parts disassembly.
1. Remove the flat head cap screws and
plastic spacer located on the under side
of the tool.
2. Install the pre-finished flooring foot and the proper
number of shims (see chart).
NOTE: FLOORING PRODUCTS WILL VARY AND THE USER MUST INSURE THE THE TOOL IS SHIMMED
PROPERLY ACCORDING TO THE FLOORING PRODUCT BEING INSTALLED. ONCE PROPERLY SHIMMED,
ONLY THE FOOT WILL CONTACT THE FLOORING.
3. Reinstall the flat head cap screws.
4. Roller adjustment: the tool is shipped with
rollers set-up for 5/8"- 3/4" range flooring.
For 1/2"- 9/16" range flooring remove o-rings,
shafts, rollers and re-install rollers in upper
holes.
Note: If desired or if proper range of
adjustment cannot be achieved, foot may be
used without rollers.
Plastic Spacer
Flat Head Cap Screws
Shim (as
required)
Shims Recommended
Flooring Thickness
1/2"
DWMIIIFS
1
Roller settings
1/2"- 9/16" flooring
5/8"- 3/4" flooring
G
3/4"
0
Publicidad
Tabla de contenido
