Congratulations on your Coleman® solar product purchase. This product is designed to the highest technical
specifications and standards. It will supply years of maintenance free use. Please read these instructions
thoroughly prior to installation, then store in a safe place for future reference. If at any time you are unclear about
this product, or require further assistance please do not hesitate to contact our trained professionals operating the
customer support line 1-888-478-6435 or email to info@sunforceproducts.com.
What's included: Wire connected to solar panel 6.7 ft. (2.04 m), extension wire 8 ft. (2.4 m), Battery Clamps,
Voltage tester with Quick Connect, 7 Amp Solar Charge Controller with Quick Connect Technology
Power Rating: Maximum rating 40 Watts (under ideal conditions)
Current: 2.3 Amps @ 17.1V
FEATURES:
•
High efficiency crystalline solar cells
•
Quickly connects and disconnects to the battery
•
Overcharge and discharge protected
•
Weatherproof design
•
Includes foldable stand
•
Conveniently comes with extension cable
•
Maintenance free, lightweight compact design
OPERATING INSTRUCTIONS
For optimal power, ensure the panel is directly facing the sunlight.
WARNING:
•
Follow the below instructions carefully to not cause any bodily harm
•
Correct polarity must be observed for product to function properly and safely
•
Risk of fire, electric shock, and injury to persons if operating instructions are not followed
•
Any misuse or tampering of the product and/or any included accessories will void warranty and may cause
bodily harm
•
Follow all safety instructions provided by the battery manufacturer when handling 12V batteries. Always wear
safety glasses. Keep sparks, flames and cigarettes away from batteries at all times.
SOLAR PANEL STAND:
On the rear of the panel, simply pull out the integrated stand. Extend stand to maximum for securing the panel.
For additional stability, add weights to the bottom of the stand (this step is optional).
CONNECTION SETUP: follow in the following order
1. Solar panel connects to the Quick-Connect extension cord
2. Quick Connect extension connects to the Solar Charge Controller at the 'SOLAR' input
3. The Solar Charge Controller connects via the 'BATTERY' output to your 12v battery (not included), use the
included 'alligator clamps' for this connection. (Red- to the positive terminal, Black to the negative terminal)
(See illustration on next page)
Typical Connection Setup
Solar Panel
Extension
Charge
wire
Controller
Battery Clamps
12V Battery (not
Included)