Product Description; Installing The Filter - Concept CA1030 Manual De Instrucciones

EN

PRODUCT DESCRIPTION

1 Air outlet
2 Control panel
3 Handle
4 Filter grid
5 Sensor
1
3
Control panel
A Air quality indicator
B Reset/Wi-Fi/Filter reminder
C Timer
D ON/OFF (Air quality indicator)
E Speed
F Child lock
B. C
56
2
4
A
D E F
CA1030

INSTALLING THE FILTER

1. Press the filter grid at the "PUSH" points to remove the filter grid.
2. Remove the filters from the appliance body and remove the packaging material.
3. Place the HEPA filter in the appliance body (with the carbon side facing out of the appliance)
4. Fit the pre-filter and snap.
5. Place back the filter grid and secure by pressing again at the "PUSH" points.
FILTER / DUST SENSOR MAINTENANCE
Pre-filter: To remove dust from the filter surface, use a vacuum cleaner or wash it with water and dry thoroughly.
HEPA + activated carbon filter: When the 1500 hour filter change prompt flashes, press and hold the reset button to
reset the timer function and the filter indicator.
5
• Disconnect the mains supply before cleaning and maintenance.
• Place the filter in a ventilated area so that harmful gases and bacteria on the filter surface can evaporate. Do not
expose it to excessive sunlight.
• Do not wash the filter with water.
• Do not work with the filter removed (operation without the effect of removing dust may cause the appliance to
malfunction).
• If the appliance is idle for a long time, unplug the power cord (it also consumes power in standby mode).
USE
When you connect the power supply, you will hear a sound, the appliance will go into standby mode and the air
quality indicator will turn red.
BOOT (ON/OFF): When the power is switched on, the air quality indicator is completely red and the appliance enters
automatic mode.
TIMER: When the appliance is running, the operating time can be set using the "timer" button. Set the time to 1 hour,
2 hours, 4 hours, 8 hours, press again to turn off, the corresponding indicator lights up after the selected time.
SPEED: Press the "speed" button to change the motor speed. It is divided into first speed, second speed, third speed,
sleep and AUTO mode. After pressing the speed button, the appliance will increase the speed by one level from the
current position and return to automatic mode.
In AUTO mode, the PM 2.5 value corresponds to the corresponding air quality table and set speed in intelligent speed
mode:
1~100 = green = excellent air quality = first speed
101~200 = yellow = good air quality = second speed
201~500 = red = poor air quality = third speed
CHILD LOCK: When the child lock button is pressed, the appliance buttons are locked and cannot be operated. To
unlock, hold the child lock button for three seconds
RESET: The appliance is equipped with a filter change warning function that flashes after 1,500 hours. Press and hold
the reset button for 5 seconds to clear the filter indicator and reset the timer function.
POWER OFF (ON/OFF): With the power on, press the "power" button and the appliance will go into standby mode. (In
standby mode, the indicator is on.)
CA1030
EN
57