Getting Started - FLIR Systems 620 Serie Manual Del Usuario

5 Video mode: Record non-radiometric
video clips
6 Sequence mode: Record radiometric
infrared sequences
7 Information mode: Camera
information
3 1
3 2
3 3
en-US
3 4
3 5
FIGURE E (Result table and
measurement tools):
1 Result table
2 Line (measurement tool)
3 Box (measurement tool)
4 Circle (measurement tool)
5 Status bar
6 Temperature scale
7 Isotherm (measurement tool)
8 Spot meter (measurement tool)
FIGURE F (Toolbox, indicators and other
items):
1 Mode indicator
2 Image mode indicator
3 Toolbox tabs
4 Toolbox
5 General information field
6 Memory Card indicator
7 System time
8 Power indicator (battery or mains
supply)
9 Battery capacity indicator
10 System date

Getting started

Turning on the camera
7 6
7 7
To turn on the camera, push the On/Off
button (B11).
7 8
Turning off the camera
To turn off the camera, push and hold the
On/Off button (B11) for more than two
seconds.
Focusing the camera
Do one of the following:
• To focus the camera, turn the focus ring
(C9) of the infrared lens clockwise/
counter-clockwise.
• To focus the camera, move the Focus
button (C3) left/right.
Autofocusing the camera
To autofocus the camera, push and release
1 1 1 2
the center of the Focus button (C3).
Auto-adjusting the image
7 3
Before you begin analyzing your image, it is
7 4
important to auto-adjust the image. An
auto-adjusted image generally makes a
7 5
good image. Manual mode will allow you to
7 6
highlight a particular detail, but this is a
7 7
more advanced mode.
1 10 1 9 1 8
• If Manual appears in the top right
corner of the screen, push the Auto/
Manual button (C2) once to auto-adjust
the image.
• If Auto appears in the top right corner
of the screen, the image is already auto-
adjusted and automatically adjusts to
the object in the image.