Gree GTH09CA-K6DNA1A/I Manual Del Usuario página 10

8
button
Press this button can select up&down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting "
louver will automatically swing up & down at maximum angle.
● When selecting " 、
position. Horizontal louver will stop at the fixed position.
● When selecting "
Horizontal louver will send air at the fixed angle.
● Hold " "button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
● " 、 、 " may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automatically.
9
CLOCK button
Press this button to set clock time. "
"+" or "-" button within 5s to set clock time. Each pressing of "+" or "-" button, clock
time will increase or decrease 1 minute. If hold "+" or "-" button, 2s later, time will
change quickly. Release this button when reaching your required time. Press
"CLOCK" button to confirm the time. "
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s. Otherwise, remote contro-
ller will quit setting status. Operation for TIMER ON/TIMER OFF is the same.
10
TIMER ON / TIMER OFF button
● TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button, "
icon disappears and the word "ON" on remote controller blinks. Press "+" or "-"
button to adjust TIMER ON setting. After each pressing "+" or "-" button, TIMER
ON setting will increase or decrease 1min. Hold "+" or "-" button, 2s later, the
time will change quickly until reaching your required time.
Press "TIMER ON" to confirm it. The word "ON" will stop blinking. "
resumes displaying. Cancel TIMER ON: Under the condition that TIMER ON is
no display
(horizontal louvers stops
at current position)
", air conditioner is blowing fan automatically. Horizontal
、 、 ", air conditioner is blowing fan at fixed
、
、 、 " , air conditioner is blowing fan at fixed angle.
" icon on remote controller will blink. Press
" icon stops blinking.
6
Floor Ceiling Type Unit
" icon
"