Toro 59302 Instrucciones De Instalación

Bagger Kit
For 2005 and Later Super Recycler Lawn Mowers
Model No. 59302
The grass bag is fully assembled and ready to use.
Installing and Removing
the Grass Bag
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side discharge chute is on the mower, remove it
and lock the side discharge door before bagging the
clippings.
Warning
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up
the rear door.
2. Remove the rear
discharge plug.
3. Route the starter rope around the lower rope
guide.
E 2005 by The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
1.
2.
m-8157
m-8182
Printed in the USA
All Rights Reserved
Installation Instructions
Note: The lower rope guide releases the starter
rope when you pull the recoil start handle.
4. Install the bag onto the door rod.
m-8158
5. Lower the rear door.
m-8169
Removing the Grass Bag
To remove the bag, reverse the steps above.
Register your product at www.toro.com
Form No. 3352-990
m-8159
Original Instructions (EN)