Chamberlain CLULP1 Guia De Inicio Rapido

Models CLULP1, CLULP1-P, CLULP1C, and CLULP1C-P
Laser Garage Parking Assist
For Service Dial Our Toll Free Number:
1-800-528-9131
114A3296E
4
FOR TWO PARKING ASSISTS ONLY
3
4
5
© 2012, The Chamberlain Group Inc.
All Rights Reserved
CAUTION
ATTENTION
LASER RADIATION
DO NOT STARE INTO BEAM
RAYONNEMENT LASER
NE PAS REGARDER DIRECTEMENT
LE RAYONNEMENT LASER
Maximum power output: < 1mW @ 635 - 670nm
Puissance de sortie maximum: < 1mW @ 635 - 670nm
CLASS II LASER PRODUCT
APPAREIL AU LASER DE CLASSE II
This Class B digital apparatus
complies with ICES-003.
1
INSTALLATION
For One Parking Assist:
1 Separate parking assist wires.
2 Strip 7/16" (11 mm) of insulation from wires.
Connect parking assist wires to the wires from the power adapter using wire nuts.
3
White to black (-) and white/black to red (+).
2
4 Reduce slack in wires. Determine desired mounting location. Mount and secure parking assist with screw and
anchor.
NOTE: DO NOT connect any parking assist or lead wires to the motor unit.
For Two Parking Assists:
1
Separate parking assist wires.
2 Strip 7/16" (11 mm) of insulation from wires.
3 Combine the white wires from the two parking assists with the black (-) wire from the transformer and twist
together with wire nut.
Combine the white/black wires from the two parking assists with the red (+) wire from the transformer and twist
4
together with wire nut.
3
5 Reduce slack in wires. Determine desired mounting location. Mount and secure parking assist with screw and
anchor.
NOTE: DO NOT connect any parking assist or lead wires to the motor unit.
SET UP AND ADJUSTMENT
1 Plug in the power adapter. The laser will continuously emit a bright red beam.
5
2 Drive your vehicle into the garage and park in the desired location.
3 Aim the red beam to a location on the dash or hood that can be easily seen while seated in the driver's seat.
4 Sit in the driver's seat and confirm that you can easily see the location of the red beam. This location is now your
point of reference for parking your vehicle.
CAUTION: Do not stare directly into the beam.
OPERATION
Drive car into garage until laser is at the desired location. DO NOT STARE DIRECTLY INTO BEAM.
TROUBLESHOOTING
If parking assist does not emit a beam:
• Make sure parking assist is aimed towards the garage floor.
• Verify nothing is blocking the parking assist lens, and laser hits the garage floor.
• Verify connections are correct and secure.
To avoid eye INJURY or damage to product:
• NEVER point the laser at anyone.
• NEVER look directly into the laser beam.
• NEVER disassemble the laser.
• The parking assist is NOT a substitute for safe parking practices.
• Use of controls or adjustments, or the performance or procedures other
than specified can result in hazardous radiation exposure.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go
to www.P65Warnings.ca.gov
www.chamberlain.com