Tools - Hdd Configuration - Conceptronic Home Media Store CH3ENAS Manual De Usuario Ampliado

ENGLISH
8.4.2 Tools – HDD Configuration
View or change the hard disk configuration for the Home Media Store.
Physical harddisks
Available volumes
USB disks
Delete disk partition
Repair hard disk
S.M.A.R.T.
Power management
Turn off harddisks after : Specify the time of inactivity before the hard disk(s) go in standby mode.
Apply
84
: Shows the technical information of the hard disk which is inside the Home Media Store.
: Shows information about the created volume on the hard disk inside the Home Media
Store. If no volume is created, you can format the hard disk with the "Format" button,
which will appear in the „Status‟ field.
: When an USB disk is connected to the Home Media Store, the information about this
USB disk (technical and volume information) will be shown in this section.
: Delete the partitions on your hard disk(s). This will erase all your data!
: Repair the hard disk(s) if there are errors.
: Enable or Disable to read S.M.A.R.T. information from your hard disk(s).
With S.M.A.R.T. enabled, the hard disk(s) can send their disk health status and
monitoring info to the Home Media Store, so the hard disk(s) can be monitored.
: Enable or Disable power management. When enabled, the Home Media Store will put
the hard disk(s) to standby when they are not used.
: Apply the configured settings.