Intellinet Network Solutions 522618 Manual Del Usuario página 2

Fast Ethernet Rackmount Switch • User Manual
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS
Rackmount Switch, Model 522618. For specifications, go to www.intellinet-
network.com.
CONNECTIONS
Use the included power cable to connect the receptacle
on the back of the switch to a power outlet, and confirm
that the Power LED lights.
• 10/100 auto sensing ports automatically
detect optimal network speeds; supports
any combination of 10 Mbps or 100 Mbps
network devices with full/half-duplex
operation.
• All ports on the switch support Auto-MDI/
MDI-X functionality, so crossover cables and
uplink ports are not needed for connections
to PCs, routers, hubs, other switches, etc.
PLACEMENT
Prior to use, it is recommended that the
switch be placed/positioned:
• on a level surface that can support the weight of the switch;
• with a minimum of 25 mm (approx. 1") of clearance on the top and sides for
adequate ventilation;
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.;
• where it cannot be affected by excessive moisture; and
• within 100 m (approx. 328') of network devices it's to be connected to.
Rackmount
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and
secure it in place with screws.
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
2
ENGLISH
48 Ports 10/100Mbps Switch
Power
Link/ACT
LED Status Operation
Power On Power on
Off Check connection
Link/ On Valid port connection
ACT Blinking Data transmitted/received
Off No link established
English
Fast Ethernet
™
1X
2X