Warranty - MTD K 17 Instrucciones De Funcionamiento Originales

Warranty

The power pack is supplied partially
charged. Before first use, fully charge
the power pack using the charger 40 V
FAST CHARGER to ensure the full
capacity of the power pack.
Note
The power pack becomes hot
during operation.
Charging indicator light
The power pack has a charging indicator
light that shows the power pack charge
status.
Press the button next to the charge
Î
indicator lamp to read off the charge
status.
3 The charge status is indicated by the
LEDs.
Status Meaning
The power pack is dis-
charged. The power pack
must be charged.
The power pack is about
25% charged.
The power pack is about
50% charged.
The power pack is about
75% charged.
The battery is 100%
charged.
Note
If a red LED illuminates, the pow-
er pack is completely discharged.
Charge the power pack.
Î
Note
General information about the
power pack
The Li-ion power pack is protected with
"Electronic Cell Protection" (ECP) against
deep discharging and overheating. If the
power pack is discharged and the power
pack temperature is greater than 70 °C,
the electrical power tool is protected by
a protective circuit so that the tool being
used no longer moves.
If the power pack is overheated, allow
Î
it to cool.
Charge the Li-ion power pack before
long periods of disuse.
Note
The lithium-ion power pack can
be charged in any charge state
and charging can be interrupted
at any time without damaging the
power pack.
Warranty
The warranty conditions of our local com-
pany or importer apply in all countries.
Under the terms of the warranty we
will repair faults on your device free of
charge, insofar that material or manufac-
turing defects are the cause. To make a
claim under warranty please contact your
seller or your nearest branch.
Note
EN
11