Sizes, mm
A
B
Desctription:
Device is used for hot air distribution. Thethermostat turns on a fan that takes the warm air to the
adjacent room or leads it out. The ventilator will switch off once the temperature drops in the room
with the heat source.
Installation and servicing (Dwg.1–4)
Caution! Before installing and servicing, please disconnect the mains power.
Caution! Only an electrician specialist may carry out installation and servicing.
Before mounting, the cover part of the ventilator must be removed by pressing with a screwdriver
on two locks under the case (Drawing 1). The ventilator must be mounted in a ventilation duct by
attaching the ventilator on the wall by the use of screws (Drawing 2). Under the cover, there are N-L
clamps to which the electrical network and thermostat must be properly connected (Drawing 3).
The device must be installed in such a way that the fan and thermostat are located in the same
room as the heat source (Drawing 4).
In case if the fan is directly connected to the electric power network, the power network must be
equipped with a switch that ensures safe disconnection of the power supply.
The desired temperature is set according to thescale specified on the thermostat. Thethermostat has a range
of 10-30 °C. The deviceshall is equipped with a non return valve providing air flow in only one direction.
Fan is equipped with two ball bearings inside of the electric motor.
Guarantee
Producer guarantee is 24 months.
In the case of damages contact the place of trade.
The guarantee does not cover:
1. noted mechanical or other damages
2. mechanical or other damages caused by incorrect or improper usage, misuse, abuse or neglect
3. mechanical or other damages caused by incorrect installation or by product's incorrect fitting to
insufficient or unsuitable power
4. mechanical or other damages caused by ignoring the instruction manual conditions
A guarantee does not cover natural wear of the product.
Information for Users on Disposal of Old Equipment. This symbol indicates that the
electrical and electronic equipment should not be disposed of as general household
waste at its end-oflife. Instead, the products should be handed over to the appliance
collection points for the recycling of electrical and electronic equipment, recovery and
recycling in accordance with your national legislation and the Directive 2002/96/EC
and 2006/66/EC.
86
41
45
EN