Description Of Parts; Technical Data; Before First Use - Sinbo SSM 2524 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23

DESCRIPTION OF PARTS

1
2
1. Temperature Control Knob
3
2. Upper Housing
3. Stainless cover
4
4. Power Light (red lamp)
5. Ready Light (green lamp)
5
6. Non-stick Cooking Plate
7. Bottom Housing
8
8. Handle
6

TECHNICAL DATA

7
Model No.: SSM-2524
Voltage: 220-240V~
Frequency: 50/60Hz
Power: 1100-1300W

BEFORE FIRST USE

• Read all instructions carefully and keep them for future reference.
• Remove all packaging.
• Clean the Cooking Plates by wiping with a sponge or cloth dampened in warm water. DO NOT
IMMERSE THE UNIT AND DO NOT RUN WATER DIRECTLY ONTO THE COOKING SURFACE.
• Dry with a cloth or paper towel.
• Lightly coat the cooking plates with a little cooking oil or a cooking spray.
NOTE: When your Waffle Maker is heated for the first time, it may emit slight smoke or odor.
This is normal with many heating appliances. This does not affect the safety of your appliance.
However, it may affect the flavor of the first set of waffles prepared in your waffle maker, and
it is recommended that you discard these.
DO NOT IMMERSE THE HEATING BODY OF THE ROTARY WAFFLE MAKER IN WATER OR ANY
OTHER LIQUID!
HOW TO MAKE GOLDEN, CRISPY WAFFLES
• Close the waffle maker and plug it into a 220~240V AC outlet, you will notice that the red
power light will go on.
• Pre-heat the waffle maker by setting the temperature control to the maximum setting, you
will notice that the green ready light will go on, indicating that the waffle maker has begun
preheating.
• It will take approximately 3 to 5 minutes to reach baking temperature. The red power light
will remain on until you unplug your waffle maker. And when the green light goes off, the waffle
maker is ready for use.
NOTE: Set the Waffle Temperature Control to your desired setting: low for light colored waffles
and higher for darker and crisp waffles, min for warming waffles. At first, try a setting in the
middle. You may later adjust it lower or higher according to your preference. Different waffle
batters will also cook up differently.
NOTE: Before baking the first waffles of the day, use a pastry brush to lightly coat the top and
bottom waffle grids with vegetable oil. A light coating of non-stick cooking spray also works
well.
• Open the waffle maker and pour batter to fill the lower cooking plate. If necessary, use a
spatula to spread the batter in to the corners of the grid.
- 7 -

Publicidad

Tabla de contenido
loading

Tabla de contenido