Program Setting - REV Ritter EMP701MT Manual De Instrucciones

GB

7. Program setting

1. Once the spike has been connected to the mains, turn the dial clockwise
until the arrow indicates the current time on the dial
2. Due to transport requirements, all pins on the timer are pressed down
upon delivery. Before programming make sure that all the pins are in the
top position.
3. Press down all pins within the period in which the spike should be enabled.
Each pin corresponds to a period of 30 minutes.
Example:
24
The current time is 9 pm.
10
To activate the earth spike from 10 pm to 2 am, press
down all the pins in the time range between 10 pm and
2 am. (See images below)