Installation Instructions - V-TAC VT-8505 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

1.
Step 2: Carefully separate
the back box from the
glass mirror and pierce
the rubber grommet.
Note: The rubber
grommet will isolate
and trap any steam
to ensure the mirror
remains protected.
3.
3.
B
A
Note: Be careful before drilling to avoid any wiring or water pipes.
Step 3: Carefully mark your desired position for the mirror using the
dimensions shown above. Then proceed to drill the holes for the Rawl plugs
and screws.
Step 1: Lay the mirror face down and
remove the screws with a Philips head
screw driver.
Note: Be careful to lay the mirror
on a padded surface, that will not
cause any scratches or abrasions.
2.
ITEM NO
VT-8505
VT-8700
VT-8701
VT-8800
VT-8601
VT-8602
ENGLISH
A(mm) B(mm)
200 300
300 500
400 600
268 268