Polaroid Candy Play 3D Pen Guia De Inicio Rapido página 8

Ocultar thumbs Ver también para Candy Play 3D Pen:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
5
Take the white internal
Candy Chamber out of
the pen.
How to clean
1. To remove any residual Candy from the Nozzle, place it in warm water
(approximately 35°C / 95°F) and leave for several minutes, allowing the
Candy to dissolve. Then use a heat resistant utensil to remove the Nozzle
from the warm water. Repeat as necessary until completely clean.
2. Ensure only the parts labelled in green on the following image are cleaned
thoroughly. DO NOT clean the parts labelled in red, as these contain
electrical components that will be damaged if they come into contact with
water, which would invalidate your Guarantee.
3. Ensure all parts are completely dry before reassembling the pen.
Reassembling the Polaroid CandyPlay 3D Pen
To reassemble the pen, follow the 6 steps from 'Taking apart the Polaroid
CandyPlay 3D pen for cleaning' but in reverse order.
Note: Before inserting a Candy Cartridge, press and hold the Retraction
button for 2 seconds.
8
6
Slide the red Piston out,
using the teeth to remove.
Parts that need cleaning
Pen
Removable
Back Panel
Do NOT Clean
DO NOT SUBMERGE
THESE PARTS IN
WATER*
*These parts contain electrical components that will be damaged
if they come into contact with water, which would invalidate your
Guarantee. To clean, wipe plastic parts only with a damp cloth.
Candy Chamber
Piston
Nozzle
Finishing
Cartridge
Nozzle Cover
Clean
These parts require
cleaning after
every use.
Do not put in the
dishwasher.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3d-fp-pl-2004-00

Tabla de contenido