Add Salt Alarm; Low Salt Cut-Out Alarm; Advanced Features - Davey DPLGEU Manual De Instrucciones

8.3. ADD SALT ALARM

The Davey Lifeguard registers conductivity from the salt probe (or from within the chlorinator cell if salt
probe not connected). Low conductivity could be triggered by cold water below 15°C (59°F), a salt
concentration below its minimum, or a cell that's in need of cleaning. To confirm the salt level
required, refer to the respective section of your EcoSalt2 manual. Refer to the relevant section following
URL: www.bit.ly/EcoSalt2. The Davey Lifeguard's HOME SCREEN shows the ADD SALT ALARM.
This can also be observed from the dashboard of the Lifeguard app.
Additional salt may be added to overcome a lower temperature. However, the maximum salt level should
also be considered and if water temperature drops too far, the system should be turned off.
Once the salt concentration is back within range (refer to the recommended salt range section in the
EcoSalt2 manual, following URL: www.bit.ly/EcoSalt2), the alarm will need to be cleared by pressing
SYSTEM ON/OFF, then Davey Lifeguard will resume normal operation.

8.4. LOW SALT CUT-OUT ALARM

Should the salt concentration continue to be diluted, the Lifeguard will enter
LOW SALT CUT-OUT ALARM.
The Lifeguard's HOME SCREEN shows the LOW SALT CUT-OUT ALARM.
This can also be observed from the dashboard of the Lifeguard app.
Once the salt concentration is back within range (refer to recommended salt range section in the
manual), the alarm will need to be cleared by pressing SYSTEM ON/OFF, then Davey Lifeguard will
resume normal operation.

9. ADVANCED FEATURES

There are several advanced features available in the Davey Lifeguard. These modes can be found in the
main menu (Figure 9.1). For any modes to be active the Davey Lifeguard must be on.
Figure 9.1
main:
-> modes
settings
maintenance
47
Figure 8.56
▲ CONTENTS