Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Storing a channel
1. Turn on the unit
2. Press
button until "M" with number 1 blinks in the bottom right side
of the display:
3. Select the desired
memory (from 1 to 9) using
4. Press
key: now the first number blinks on the left side of the display.
5. Select the desired channel to be stored ( from 1 to 69) using
keys.
6. Press
button: you'll see the flashing on the right of the channel just
stored. CTCSS also blinks in the upper left side.
7. Select the desired CTCSS tone using
If you desire no tone, press
key when "CTCSS 00" appears on display.
To insert a DCS tone:
1. Press
button ("DCS" will blink on the display)
2. Select the desired DCS tone using
If you desire no tone, press
key when "DCS 00" appears on display.
Channel Recall
To recall the stored channel follow these instructions:
1. Press
button until a number (from 1 to 9) blinks in the bottom right
side of
the display
2. Use the
/
keys to run the stored channels
3. If a memory is empty, the memory channel blinks; if a channel has been
stored, the number remain fixed.
4. Press
key to end the operations.
When turning on /off the radio, the stored channels remain memorised in your
ALAN 516.
Power save
This function allows an automatically save of the power. If you receive no
signals for 5 secs. max the "Power save" function is activated reducing
at minimum the consumption extending the battery life.
/
keys.
/
/
keys.
/
keys.
11
Battery level
The battery level indicator is visualised on the display. The number of segments
indicates the battery level.
When
icon blinks, replace the alkaline batteries or recharge Ni-Cd
batteries.
Reset
If ALAN 516 presents some malfunctionings or you want to cancel all the
setting, you can make a reset by pressing
switching on of the radio.
button for 3 secs during the
12
Publicidad
Capítulos
Tabla de contenido
