System Requirement; Troubleshooting; Fcc Statement - Cool-Icam S1000 Manual Del Usuario

Self timer
PC interface
Power source

9. System requirement

Operating system
CPU
RAM
Interface

10. Troubleshooting

Problem
Cannot turn on the camera
Photos cannot be saved when
taking pictures.
Cannot find removable disk
after connecting the camera to
.
the computer
Flash does not work.
Batteries are depleted quickly.
The photos are blurry

FCC Statement

Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
10 seconds
USB 2.0
2 x AAA alkaline batteries
Win XP (SP3)、Vista32/64 Win7 32/64 and Mac OS X 10.6.8 or
above
Pentium 4 / 3.0G or faster recommended
1 GB MB RAM (Vista : 2 GB)
USB port
Cause
Low battery power.
Batteries placed at
incorrect polarities.
The memory card hasn't
been formatted properly.
Connection failure.
Battery power is too low.
Incorrect or old, battery
1. The camera is not held
steady
2. The lens of the camera
is dirty.
EN-8
Solution
Replace or install the batteries
correctly.
Format the memory card in setup
mode of the camera. Please refer to
section 5.3.
Make sure all cable connections are
secured and restart the computer if
necessary.
Try a different USB port
Replace with new 2 x AAA alkaline
batteries
Replace with 2 x AAA alkaline
batteries
1. Hold the camera stead until it
beeps when taking photos.
2. Clean the lens with a soft dry cloth.