Publicidad
Idiomas disponibles
Idiomas disponibles
Eclipse
1/4 new
1/2 new
3/4 new
full
3/4 old
1/2 old
1/4 old
II Operating instructions:
Installing batteries and syncing main receiver with sensor:
1. Remove battery housing cover on the back of the main receiver and insert 2 x AAA batteries.
Replace housing cover.
2. Remove mounting bracket from the back of the sensor as illustrated in FIG. 2. Then use a screw driver
to remove battery housing cover and insert 2 x AAA batteries. Before replacing housing cover, ensure
CH switch is set to CH 1. Also select whether you would like Celsius/Fahrenheit by pressing the "°C/°F"
button. When replacing battery housing cover, ensure that the rubber seal is correctly in position to
ensure batteries are protected from the weather.
3. When batteries are in place, the units will automatically detect the current temperature and humidity
after 3 seconds. If outdoor temperature is not displayed, press "CHANNEL" until the number "1" appears
below the "OUTDOOR CH" icon.
Note the current conditions will update every 60 seconds.
4. If you want to reset current temperature information press and hold the "CHANNEL" button for 2
seconds.
Fig.2
Note: If faint LCD display please replace the battery.
It is advisable not to exceed 25 meters distance (in open field) between the receiver and the sensor.
Common mode:
1. Press "TIME" for 2 seconds for time setting.
2. Press "ALARM" to turn on or off alarm after you set the time.
3. Press "ALARM" for 2 seconds for alarm setting.
4. Press "UP" for 12HR/24HR format switch.
5. Press "DOWN" for Celsius/Fahrenheit switch.
6. Press "CHANNEL" to change channel: CH1 ~ CH2 ~ Ch3.
7. Press "CHANNEL" for 2 seconds, clear all the channels' present information.
8. Press "SNZ" to snooze the alarm for 5 minutes when alarm is activated.
Setting the time:
1. Press "TIME" for 2 seconds, the numbers will flash.
2. Set hour by pressing the "UP" or "DOWN" buttons. When correct hour appears, press "TIME". Repeat for
HOUR,
MINUTE, YEAR, MONTH, DATE, LANGUAGE, Please note the flashing symbols under "DAY" refer to the
language EN
(ENGLISH), IT(ITALIAN), FR(FRENCH),NE(DUTCH),ES(SPANISH), DA(DANISH) and GE(GERMAN).
3. Press "TIME" to confirm.
6
Publicidad
