Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the alarm:
1. To set alarm time, press "ALARM" for 2 seconds (the numbers will flash). To turn on alarm, press the
"ALARM" button (an
alarm bell symbol will appear in between hour and minute digits).
2. Set alarm time by pressing "UP" or DOWN" buttons. Setting sequence: hour~ minute- exit. When you
have the
desired time press "ALARM" to exit.
3. To activate the alarm, press the "ALARM" button once to activate the alarm (bell symbol will appear
next to the time) and
press "ALARM" again to deactivate it (bell symbol will disappear).
4. When the alarm goes off, it will beep incrementally faster the longer you leave it. You may press the
"SNZ" button to
snooze the alarm for 5 minutes or you may turn off the alarm by pressing the "ALARM" button once. The
alarm will stay
activated (see bell symbol) unless you press the "ALARM" button again to turn off the alarm (bell symbol
disappears).
Information on disposal for users of waste electrical & electronic equipment.
This symbol on the products and/or accompanying documents means that used electrical and
electronic products should not be mixed with general household waste. For proper treatment,
recovery and recycling, please take these products to designated collection points, where
they will be accepted on a free of charge basis. Disposing of these products correctly will help
to save valuable resources and prevent any potential negative effects on human health and
the environment which could otherwise arise from inappropriate waste handling. Please contact your
local authority for further details of your nearest designated collection point.
7
Publicidad
