Utilitech NTH15-19J Manual Del Usuario página 6

10.This heater draws 12.5 A during operation. To prevent overloading a circuit,
do not plug the heater into a circuit that already has other appliances
working.
11.CAUTION: It is normal for the plug to feel warm to the touch; however, a
loose it between the AC outlet (receptacle) and plug may cause overheating
and distortion of the plug. Contact a qualified electrician to replace loose or
worn outlet.
12.To disconnect the heater, first turn controls to off, then remove plug from
outlet. Never pull by the cord.
13.Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
14.To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surface, like a bed, where openings may become
blocked.
15.A heater has hot and arcing or sparking parts inside. Do not use it in the
areas where gasoline, paint, or flammable liquids are used or stored.
16.Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
17.CAUTION: Always plug heaters directly into a wall outlet/receptacle. Never
use with an extension cord or relocatable power tap (outlet/power strip).
18.The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid burns.
19.Disposal of oil contained within should be in accordance with applicable
regional, national, and local laws and regulations.
20.CAUTION: TO PREVENT ELECTRIC SHOCK, MATCHWIDE BLADE OF
PLUG TO WIDE SLOT AND FULLYINSERT.
21. Warning: This heater cannot provide professional-grade temperature
control and should not be used to keep a storage unit from freezing or to
maintain temperature for animals, pets, plants, etc.
SAVE THESE INSTRUCTIONS
5