Sanus CATG01 Manual De Instrucciones página 5

1 Install Temperature Gauge
2 Plug in Temperature Gauge
[01]
6901-002136 <01>
Mount CATG01 [01] to the front of the rack at any 1U
location on the rack rails using four 10-32 x ¾ in. screws
(not included).
Make sure the master power switch of the CAPT01
SANUS EcoSystem™ Multi-volt Power Supply is in the
off position. Plug the power cord of the CATG01 [01]
into one of the 12V DC "always on" jacks of the CAPT01.
Position the end of the thermo sensor wire where you
want to obtain a temperature reading. NOTE: only the
end of the thermo sensor wire will detect temperature.
[01]
1U
5