Tabla de contenido
Publicidad
ENGLISH
TABLE OF CONTENTS
1. Power On/Off/Pair
2. Volume Control
3. Audio IN
4. Micro USB IN
5. Belt clip
Getting Started:
1. A long press on the button
(1) turns the speaker on/
off. White LED is now on. If
a paired device is found, the
LED shines without blinking
and your speaker is ready to
use.
2. If no device is found the
speaker LED continues to
blink and enters pairing
mode automatically. Go to
the Bluetooth settings in your
mobile device and connect
to FREKVENS 6x10. The LED
should now stop blinking and
your speaker is ready to use.
If no music has been playing
for 20min, the speaker will
enter sleep mode.
Adjust Volume
Turn the knob (2) left to
decrease or turn it right to
increase volume level.
Pair Bluetooth device(s)
(maximum 8 devices can be
stored)
1. Make sure no other device
is paired and in range to the
speaker.
2. Go to your Bluetooth menu
on your mobile device and
connect to FREKVENS 6x10.
3. Once Bluetooth connection
is established, the white LED
stops blinking.
Unpair Bluetooth device
Go to your Bluetooth menu on
your mobile device and unpair
FREKVENS 6x10 from your
devices.
Using an external source
Connect the external source
to the AUDIO IN (3) jack on
the rear panel.The speaker
automatically detects the
external input and disables
Bluetooth functionality. Use a
3.5mm 3-pol Audio cable for this
feature.
Charging the speaker
When battery is low a red LED
(1) will flash. During charging
the red LED is on.
To charge connect the speaker
(4) with the MicroUSB cable to a
4
Publicidad
Tabla de contenido
