Chamber G21 Manual página 5

Warning matters
1. The input voltage is 220-240 V, 50/60 Hz, please confirm it before using.
2. If the power cord is damaged, it must be replaced or repaired by authorized repair shop, do
not replace it with other power cord.
3. If product needs to be repaired, please contact customer service center or go to authorized
repair shop, do not repair it privately.
4. Please make sure to cut off the power before dismantling, installing or debugging the machine.
5. Before operating the appliance, please check the cord or plug, squeezing cone, squeezing
screw and other components. If any component has been damaged please discontinue using the
appliance and contact nearest service center. Please don't dismantle and repair by yourself for
safety.
6. The appliance has intelligent protection chip, it will automatically stop after 20 minutes conti-
nuous work. To prolong the service life of the product, please stop for 20-30 minutes and let the
motor cool down.
7. Always disconnect the appliance from the power if it is left unattended and before assembling,
disassembling or cleaning.
8. Keep the appliance and its cord out of reach of children.
9. This appliance is not intended for use by persons (including children) with limited physical,
sensual or mental capabilities, or with lack of experience and knowledge, unless they have been
given supervision or instructions regarding use of the appliance by a person responsible for their
safety.
10. Children should not play with the appliance.
11. The product will automatically stop working and cease after reverse for a few seconds when it
overload or motor locked. While it gives the warning tone, you cannot continue to use the product
until warning tone stops. Before next use clean up material in feeding tube.
12. Cut ingredients into pieces which can be put into feeding tube. If materials have core hard
seed thick peel and hard shell please remove them before processing.
13. Before turning on the power, make sure that detachable parts have been installed. Feeding
tube and feeding tube cover should twist to tight to avoid falling off and spilling the content.
14. The parts which come into contact with food should comply with the requirements on materi-
als that may come into contact with food. The containers must be clean and wholesome.
15. It is normal phenomenon and not harmful for health if the squeezing screw, squeezing cone,
feeding tube, juice container and other parts may be colored by fruits.
16. Start machine after finishing throwing material into feeding tube in order to avoid damage
parts.
17. Do not use steel velvet, abrasive cleansers or corrosive liquid (for example Gas or Acetone) to
clean the appliance.
18. Do not heat any part.